FLX1510 FLEX ARM
The second generation FLX-1510 Flex Arm allows the operator to travel on the road while his Schulte 10’ or 15’ rotary cutter cuts the ditch slope. Increased safety, operator comfort and cutting performance is achieved, as the Flex Arm holds its position on a steep ditch bank, better than any competitive offset arm. Castor wheel locations are ideal on the new Flex Arm. The left wheel rides on the road and out of the cutting area. The ditch wheel is located at the overlap point between the center & wing blade sets, the best location to pick up the wheel track. The FLX-1510 is 4” higher than the previous model so even the steepest ditches can be mowed. In addition, the offset keeps the mower close to the tractor - only 10’ away. The Schulte FLX-1510 incorporates swivel gearboxes, which means there are no telescoping drivelines to maintain on the frame of the Flex Arm. The Flex Arm requires only one cv shaft to operate, and the drive train can accommodate either 540 or 1000rpm mowers. Powerdelivery is equally smooth in all positions of the Flex Arm.